Configuration Wizards
Using the Setup Wizard for the Initial Configuration
Cisco ISA500 Series Integrated Security Appliances Administration Guide 39
2
STEP 10 Use the License Installation page to validate the security license, which is used to
activate security services on the device.
STEP 11 If the security license is already installed on the security appliance, click Next to
proceed next step.
STEP 12 If the security license is not installed on the securit y appliance, enter the following
information to validate the security license:
•Email Address: Enter the registered email address to receive the PAK ID.
•PAK I D: Enter your Product Authorization Key in this field. You can find the
license code from the Software License Claim Certificate that Cisco
provides upon purchase of the security appliance.
NOTE: A valid Cisco.com account is required to validate the security license.
If your Cisco.com account credentials are not configured, go back to the
Cisco.com Credentials page to configure them.
NOTE: If you want to continue the Setup Wizard configuration without installing the
security license, check the box next to Continue without installing license (not
recommended ). The security services cannot be activated without installing the
security license.
STEP 13 After you are finished, click Next.
Enabling Bonjour and CDP Discovery Protoc olsSTEP 14 Use the Discovery page to enable Bonjour and/or CDP discovery protocols on the
security appliance. For optimal device discovery and topology support via the
OnPlus portal, enable both discovery protocols.
•Enable Bonjour Discovery Protocol: Check this box to enable Bonjour
discovery protocol, or uncheck this box to disable it.
•Enable Cisco Discover y Protocol (CDP): Check this box to enable Cisco
Discovery Protocol (CDP), or uncheck this box to disable it.
NOTE: Discovery protocols are only operational on the LAN ports of the
security appliance.
STEP 15 After you are finished, click Next.