Configuration Wizards
Using the Setup Wizard for the Initial Configuration
Cisco ISA500 Series Integrated Security Appliances Administration Guide 48
2
-802.11b/g/n mixed: Choose this mode to allow 802.11b, 802.11g, and
802.11n clients operating in the 2.4 GHz frequency to connect to the
access point.
-802.11n only: Choose this mode if all devices in the wireless network
can support 802.11n. Only 802.11n clients operating in the 2.4 GHz
frequency can connect to the access point.
•Wireless Channel: Choose a channel from a list of channels or choose Auto
to let the system determine the optimal channel to use based on the
environmental noise levels for the available channels.
STEP 38 After you are finished, click Next.
Configuring Intranet WLAN Access
STEP 39 If you turned the wireless radio off, proceed to Viewing Configuration Summary,
page 50. If you turned the wireless radio on, use the Intranet WLAN Access page
to configure the wireless connectivity settings for the SSID called “cisco-data.”
•SSID Name: The name of the SSID.
•Security Mode: Choose the encryption algorithm for data encryption for this
SSID and configure the corresponding settings. For complete details, see
Configuring Wireless Security, page 211.
•VLAN Name: Choose the VLAN to which this SSID is mapped. All traffic from
the wireless clients that are connected to this SSID will be directed to the
selected VLAN. For Intranet VLAN access, you must choose a VLAN that is
mapped to a trusted zone.
NOTE: ISA550W and ISA570W support four SSIDs. To configure the
wireless connectivity settings for other SSIDs, go to the Wireless > Basic
Settings page (see Configuring SSID Profiles, page 210), or use the Wireless
Wizard (see Using the Wireless Wizard (for ISA550W and ISA570W only),
page76).
STEP 40 After you are finished, click Next.