Configuration Wizards
Using the Setup Wizard for the Initial Configuration
Cisco ISA500 Series Integrated Security Appliances Administration Guide 44
2
-DHCP Server: Allows the security appliance to act as a DHCP server and
assigns IP addresses to all devices that are connected to the LAN. Any
new DHCP client joining the LAN is assigned an IP address of the DHCP
pool.
-DHCP Relay: Allows the security appliance to use a DHCP Relay. If you
choose DHCP Relay, enter the IP address of the remote DHCP server in
the Relay IP field.
STEP 27 If you choose DHCP Server as the DHCP mode, enter th e followi ng infor mation :
•Start IP: Enter the starting IP address of the DHCP pool.
•End IP: Enter the ending IP address of the DHCP pool.
NOTE: The Start IP address and End IP address should be in the same
subnet as the LAN IP address.
•Lease Time: Enter the maximum connection time that a dynamic IP address
is “leased” to a network user. When the time elapses, the user is
automatically renewed the dynamic IP address.
•DNS1: Enter the IP address of the primary DNS server.
•DNS2: Optionally, enter the IP address of the secondary DNS server.
•WINS1: Optionally, enter the IP address of the primary WINS server.
•WINS2: Optionally, enter the IP address of the secondary WINS server.
•Domain Name: Optionally, enter the domain name for the default LAN.
•Default Gateway: Enter the IP address of default gateway.
STEP 28 After you are finished, click Next.
Configuring DMZ
STEP 29 If you have not configured a DMZ port, proceed to Configuring Wireless Radio
Settings, page 47. If you configured a DMZ port , use the DMZ Configuration page
to configure a DMZ network.
•IP Address: Enter the subnet IP address for the DMZ.
•Netmask: Enter the subnet mask for the DMZ.