Installing and Removing Components
Installing and Removing a Power Distribution Unit (PDU)
Installing and Removing a Power Distribution Unit (PDU)
Caution The Power Distribution Unit should only be replaced by a Cisco certified technician. This section is for reference only.
Caution You can not hot swap a PDU
Installing a PDU
Procedure
Step 1 Hold the PDU module from below, with the captive screws at the top of the module.
Figure 38: Positioning a PDU (N01-UAC1) in the Cisco UCS Server Chassis, AC Version
195360
1 |
Step 2 Push the PDU module into the chassis until it seats properly. If power supplies are installed, you may need to partially remove them.
Step 3 Tighten the captive screws.
Step 4 If necessary, reseat the power supplies and restart the system to observe LED behavior.
Cisco UCS 5108 Server Chassis Installation Guide
62 |
|
