Citizen CT-S300 manual G3S W, Fs P, Ff, Can, Esc Ff, Esc S, Esc T, Esc W, Gs W, Gs

ESC L

[Function]	Selecting PAGE MODE
[Code]	<1B>H<4C>H
[Outline]	Switches from STANDARD MODE to PAGE MODE.
[Caution]	• This command is only effective if it entered at the beginning of a line.
	• This command is not effective if it is entered when in PAGE MODE.
	• STANDARD MODE is restored when printing specified by FF is finished or when
	ESC S is issued.
	• The character mapping start position will be the point specified by ESC T in the
	print area specified by ESC W.
	• The commands listed below, which have separate settings for PAGE MODE and
	STANDARD MODE, are changed to the settings for PAGE MODE use.
	(1)	Spacing setting: ESC SP, FS S
	(2)	Line feed width setting: ESC 2, ESC 3
	• The following commands are valid only in PAGE MODE.
	(1)	ESC V	Specifying/canceling 90°-right-turned characters.
	(2)	ESC a	Aligning the characters.
	(3)	ESC {	Specifying/canceling the inverted characters.
	(4)	GS L	Setting the left margin.
	(5)	G3S W	Setting the print area width.
	• The following commands are disabled in PAGE MODE.
	(1)	GS ( A	Executes test printing.
	(2)	FS P	Prints NV memory bit image.
	(3)	FS q	Defines NV memory bit image.
	(4)	GS v 0	Prints raster bit image.
	• ESC @ restores STANDARD MODE.
[See Also]	Appendix 4.1.4 “Example of using PAGE MODE”
	FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS W, GS \

— 122 —