
2.2.10 Cutter Commands
GS V m ......... (1)
GS V m n ..... (2)
[Function] | Cutting the paper | |
[Code] | (1) | <1D>H<56>H<m> |
| (2) | <1D>H<56>H<m><n> |
[Range] | (1) | m = 1, m = 49 |
| (2) | m = 66 |
[Outline] | Performs the specified paper cutting. | ||
|
|
|
|
|
| m | Function |
| 0, 48 | Full cut | |
|
|
|
|
| 1, 49 | Partial cut (Leaving a bridge area uncut) |
65Paper feed by “cut position + {n ⋅ basic calculation pitch}” and partial cut
66Paper feed by “cut position + {n ⋅ basic calculation pitch}” and partial cut
[Caution] | • In STANDARD MODE, this command only works when it is entered at the beginning |
| of a line. |
| • Control to make the length of cut paper less than 10 mm is not excecuted. |
| For (1): |
| • Executes cutting of paper. |
For (2):
•If n = 0, the paper is fed to the cut position, and then cut. If n ≠ 0, the paper is fed by “n ⋅ basic calculation pitch” inches past the cut position, and then cut.
•The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic calculation pitch (y).
A fraction resulting from the calculation is corrected with the minimum pitch of the mechanism, and the remainder is omitted.
— 65 —