Datacard Group ImageCard SelectTM and UltraGrafix SelectTM Printers manual Maintaining the printer

4-8 Maintaining the printer

iDo not place the pen next to the black transport base. The pen can get pinched between the roller and the transport base.

cDo one of the following to turn the rollers in the printer.

•Click the “Printer” button in the Clean area. Click OK on the prompt that appears. Do not insert a cleaning card! The driver sends a command to the printer to run the printer cleaning card. The printer moves rollers when it attempts to pick the card.

•Turn the card advance knob to move rollers by hand.

dMove the pen on the roller.

eLightly wipe any dirt from the end of the cleaning pen onto a clean cloth or paper. Move the cleaning pen to another area of the roller.

fRepeat steps c through e for the roller at location 1 until no more dirt appears on the pen or cloth.

gMove the cleaning pen to location 2 (in Figure 4-8). Repeat steps c through f.

hIf the printer has a magnetic stripe module, move the cleaning pen to location 3 (in Figure 4-8). Repeat steps c through f.

iReplace the print ribbon cartridge and close the swing arm.

If the printer does not have a duplex or smart card module, Go to step 5.

If the printer has a duplex or smart card module, continue with step 4.

4If the printer has a duplex module or a smart card module, clean the exit roller. a Begin with the swing arm down and latched, and the module door open.

b Insert the cleaning pen through the module door and hold the end of the cleaning pen against the top of the lower exit roller (location 4 in Figure 4-8).

c Do one of the following to turn the rollers in the printer.

•Click the “Printer” button in the Clean area. Click OK on the prompt that appears. Do not insert a cleaning card! The driver sends a command to the printer to run the printer cleaning card. The printer moves rollers when it attempts to pick the card.

•Turn the card advance knob to move rollers by hand.

dMove the pen on the roller.

eLightly wipe any dirt from the end of the cleaning pen onto a clean cloth or paper. Move the cleaning pen to another area of the roller.

fRepeat steps c through e for the roller at location 4 until no more dirt appears on the pen or cloth.

gClose the printer top cover and the module door.

5 Replace the card cartridge.

EIf the printer has a locking card cartridge, lock the cartridge after replacing it.

User’s Guide for ImageCard® Select™ and UltraGrafix® Select™