Programming Parameters

Programming Codes Without Parameters

The following table describes the functions of special bar codes that take no parameters:

Table F-1. Programming Codes Without Parameters

Code

I.D. #

Function

Parameter

 

 

 

 

 

 

 

 

Defaults

FF39

Turns every On/Off parameter off and sets all minimum and

Minimum

Maximum Label Lengths to the lowest values.

 

 

Turns every On/Off parameter on and sets all minimum and

Defaults

FF3A

Maximum Label Lengths to the highest values. This default set

is normally used only for troubleshooting. It gives the best

Maximum

 

 

chance of reading an unknown bar code symbology and also

 

 

identifies the symbology of each bar code scanned.

Defaults

FF3B

This is the default parameter settings that was installed at the

Factory

factory. This default set will work for most applications.

 

 

This restores all parameter settings to the values that exist in

Defaults

FF3C

the registry. This is useful for restoring parameters to a known

Registry

working set of values which have been saved using code

 

 

parameter FF3F.

Exit andFF3D

Stops a label programming sequence and restores all parame-

Restore

ter settings to the values that exist in the registry.

Exit and

FF3E

Stops a label programming sequence. The last valid parameter

Save

settings are left intact.

 

 

Stops a label programming sequence and writes all parameter

Exit and

FF3F

settings into the registry. This can be used to save a custom-

Commit

ized set of parameter settings for restoring later via parameter

 

 

FF3C.

F-2

Falcon® 4400 Series with Windows® CE