Datalogic Scanning 4410, 4420 Installing a Handle on the Falcon

Installing the Handle or Handstrap

3.Replace the screws located just above the battery cover’s latch dials.

4.Connect the handstrap hook onto one of the strap studs at the base of the Falcon.

5.The process is complete upon successful test of the scanning function.

Installing a Handle on the Falcon 4410

To install the handle on the Falcon 4410, complete the following steps:

1.Remove the handstrap as shown in Figure A-10by removing the screws located just above the battery cover’s latch dials.

Figure A-11. Removing/Replacing the Handle

Handle

PDT

Product Reference Guide A-9