Datalogic Scanning 4410, 4420 Imaging Controls, Mode, Accep, Width, minate, Enable, Enable, Enable, Height, Imaging, Imaging, Defaults, Image LED, ter Enable, Table F-4.Imaging Controls

Programming Parameters

Table F-4. Imaging Controls

			I.	Accep-		Defaults
	Code Parameter/ Description		D.	table
					Min	Max	Factory
			#	Input
Imaging Controls				Enter 1 for On and 0 for Off.
Imager Illu-		Instructs the PDT to illuminate the scanning	0
			0	On or
minate		area (independent of any targeting beam)			On	On	On
			0	Off
Enable		when using an imager.
			8
		Toggles between two different operating
		modes for the targeting beam:	0
		Concurrent (Off): The targeting beam is
Imager Aim			0	On or
		turned on at the same time as an enabled			On	On	On
Mode			0	Off
		illumination beam.
			9
		Interlaced (On): Toggles the aimer and illu-
		mination beam.
			0
Imager Aim		Instructs the PDT to make use of a target-	0	On or	On	On	On
Enable		ing beam when an imager is installed	0	Off
			A
			0
Image LED		Instructs the imager to use LED illumination	C	On or	Off	Off	Off
Enable		when taking images.	0	Off
			8
		Instructs the imager to use a filter that	0
Image LR Fil-			C	On or
		improves the quality of images taken at			Off	Off	Off
ter Enable			0	Off
		longer distances.
			9
			0	1 to 640
Imaging		Specifies the width of images taken with an	C
				(in pix-	640	640	640
Width		imager	2
				els)
			3
			0	1 to 480
Imaging		Specifies the height of images taken with	C
				(in pix-	480	480	480
Height		an imager.	2
				els)
			4

F-32 Falcon® 4400 Series with Windows® CE