Dell 2950 E1811 HDD ## Rbld Abrt, E1812 HDD ## Removed, E1913 CPU & Firmware, Mismatch

Table 1-6. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1811	HDD ## Rbld Abrt	The specified hard drive has	See "Troubleshooting a Hard
		experienced a rebuild abort.	Drive" on page 124. If the
			problem persists, see your RAID
			documentation.
E1812	HDD ## Removed	The specified hard drive has been	Information only.
		removed from the system.
E1913	CPU & Firmware	The BMC firmware does not	Update to the latest BMC
	Mismatch	support the CPU.	firmware. See the BMC User’s
			Guide for more information on
			setup and use of BMC.
E1A11	PCI Rsr Config	PCI risers are not configured	See "Expansion-Card Riser
		correctly; some invalid	Boards" on page 98.
		configurations may prevent the
		system from powering on.
E1A12	PCI Rsr Missing	One or all of the PCI risers is	Information only.
		missing, preventing the system
		from powering on.

E1A14 SAS Cable A SAS cable A is missing or bad.

Reseat the cable. If problem persists, replace cable. See "SAS Controller Daughter Card" on page 69.

E1A15 SAS Cable B SAS cable B is missing or bad.

Reseat the cable. If problem persists, replace cable. See "SAS Controller Daughter Card" on page 69.

E2010	No Memory	No memory is installed in the	Install memory. See "Installing
		system.	Memory Modules" on page 90.
E2011	Mem Config Err	Memory detected, but is not	See "Troubleshooting System
		configurable. Error detected	Memory" on page 120.
		during memory configuration.
E2012	Unusable Memory	Memory is configured, but not	See "Troubleshooting System
		usable. Memory subsystem	Memory" on page 120.
		failure.
E2013	Shadow BIOS Fail	The system BIOS failed to copy	See "Troubleshooting System
		its flash image into memory.	Memory" on page 120.
E2014	CMOS Fail	CMOS failure. CMOS RAM not	See "Getting Help" on page 147.
		functioning properly.
E2015	DMA Controller	DMA controller failure.	See "Getting Help" on page 147.

24

About Your System