Removing a SAS Controller Daughter Card

1Disconnect any battery connectors if applicable.

2Disconnect the control panel cable. See "Removing the Control Panel Assembly" on page 105

3Disconnect any SAS cables from the card.

4Gently press down on the release tab while sliding the SAS controller daughter card in its tray away from the sideplane connector, freeing the chassis slots on the tray from the chassis hooks, and lifting the card from the system. See Figure 3-12.

RAID Battery

Installing a RAID Battery

1Insert the RAID battery into the battery carrier. See Figure 3-17.

2Locate the battery bay to the right of the SAS daughter card on top of the hard drive bays.

3Insert the battery carrier and RAID battery into the chassis battery carrier slots and connect the battery cable to the storage daughter card, ensuring that the battery carrier is aligned and fully seated in the slots.

74

Installing System Components

Page 74
Image 74
Dell 2950 owner manual Removing a SAS Controller Daughter Card, Installing a RAID Battery