Dell 4100/180, 4100/200 manual Reserved do not change

Figure C-1. System Board Jumpers

Table C-1. System-Board Jumper Settings

Jumper Setting Description

EISA

EVGA

PSWD

CARDBIOS

RSRVD2

RSRVD1

(default)	The EISA Configuration Utility settings are
	retained at system boot.
	The EISA Configuration Utility settings are
	cleared at next system boot. (If the EISA Configu-
	ration Utility becomes corrupted to the point where
	the system won’t boot, install the jumper plug and
	boot the system. Remove the jumper before restor-
	ing the EISA configuration information.)
(default)	The integrated video controller is enabled.
	The integrated video controller is disabled.
(default)	The password feature is enabled.
	The password feature is disabled.
	Reserved (do not change).
	Reserved (do not change).
	Reserved (do not change).

200MHZ*

The microprocessor’s internal speed is 200 MHz.

180MHZ*

The microprocessor’s internal speed is 180 MHz.

*Only one of these jumpers should have a jumper plug installed.

NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.

Jumpers and Switches C-3