Dell 4100/180, 4100/200 manual System Setup Program, Eisa Configuration Utility

Table 2-1. Boot Routine Indications

Listen for: Action

An unfamiliar constant scraping or grinding sound when you access a drive

Make sure the sound is not caused by the application program you are running. The sound could be caused by a hardware mal- function. See Chapter 11, “Getting Help,” for instructions on getting technical assistance from Dell.

The absence of a familiar sound	When you turn on the system, you should hear the hard-disk
	drives spin up, and the system tries to access the boot files from
	the hard-disk drive, the diskette drive, or CD-ROM drive. See
	Chapter 5, “Running the System Diagnostics.” If the system
	does not boot, see Chapter 11, “Getting Help.”

If after looking and listening to the computer you have not resolved the problem, continue with the instructions in “The System Setup Program” found next in this chapter.

The System Setup Program

You can easily correct certain system problems by verify- ing the correct settings in the System Setup program. When you boot the system, the system checks the system configuration information and compares it with the cur- rent hardware configuration. If the system hardware configuration doesn’t match the information recorded by the System Setup program, an error message may appear on the screen.

This problem can happen if you changed the system’s hardware configuration and forgot to run the System Setup program. To correct this problem, enter the System Setup program, correct the corresponding System Setup category, and reboot the system. See Chapter 4, “Using the System Setup Program,” in the system User’s Guide for detailed instructions on using the System Setup program.

The EISA Configuration Utility

If you are experiencing problems with the system, you may have a conflict between the information stored by the System Setup program and the EISA Configuration Utility. Although the EISA Configuration Utility can read changes from the System Setup program, the change is not recorded into EISA configuration memory until you run the EISA Configuration Utility and save the new information. See Chapter 5, “Using the EISA Configura- tion Utility,” in the system User’s Guide for detailed instructions on using the EISA Configuration Utility and saving new information.

If after using the EISA Configuration Utility you have not resolved the problem, see Chapter 5, “Running the System Diagnostics,” in this guide.

2-6 Dell PowerEdge 4100/180 and 4100/200 Systems Installation and Troubleshooting Guide