CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
Removing the Front Drive Bezel
1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening the System" on page 47.
NOTE: The sliding plate secures and releases the front drive bezel and helps to secure the drives.
3Slide the lever on the sliding plate in the direction of the arrow until it releases the front drive bezel from its side hinges. See Figure
4Carefully tilt the front drive bezel away from the chassis and lift it out as shown in Figure
5Close the system. See "Closing the System" on page 47.
Replacing the Front Drive Bezel
1With the front drive bezel tilted away from the chassis, place the bottom tabs of the bezel into their slots of the chassis. Refer to the lower arrow in Figure
2Snap the bezel into place.
Installing System Components
49
