Dell T310 owner manual Removing a Non-Redundant Power Supply, screws

Removing a Non-Redundant Power Supply

1Turn off the system and all attached peripherals.

2Disconnect the power cable from the power supply.

3Open the system. See "Opening the System" on page 85.

4Disconnect all cables from the power supply to the system board, hard drives and optical drive.

5Loosen the three screws securing the power supply to the chassis and lift the power supply to remove it from the chassis. See Figure 3-15.

Figure 3-15. Removing and Replacing a Non-Redundant Power Supply

1

2

1 non-redundant power supply 2 screws (3)

Installing System Components

105