Dell T310 owner manual Removing a Processor

Processor

Removing a Processor

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Prior to upgrading your system, download the latest system BIOS version from support.dell.com and follow the instructions included in the compressed download file to install the update on your system.

2Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. When disconnected from AC power, press and hold the power button for 3 seconds to fully drain the system of stored power prior to removing the cover.

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.

3Open the system. See "Opening the System" on page 85.

4Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer" on page 87.

5Remove the cooling shroud. See "Removing the Cooling Shroud" on page 88.

WARNING: The heat sink and processor are hot to touch for some time after the system has been powered down. Allow the heat sink and processor to cool before handling them.

CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper thermal conditions.

6Using a #2 Phillips screwdriver, loosen one of the heat-sink retention screws. See Figure 3-22.

7Wait for 30 seconds for the heat sink to loosen from the processor.

8Repeat step 6 and step 7 to loosen the three heat-sink retention screws.

126

Installing System Components