Dell T310 owner manual detected when powering, A fatal system error has

Table 1-2. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E122A	CPU # VTT	Specified processor VTT	Reseat the processor.
	Regulator	voltage regulator has failed. See "Troubleshooting the
	failure.		Processor" on page 163.
	Reseat CPU.		If the problem persists,

see "Getting Help" on page 177.

E122C CPU Power	A power fault was
Fault. Power	detected when powering
cycle AC.	up the processor.

Remove AC power to the system for 10 seconds and restart the system.

If the problem persists, see "Getting Help" on page 177.

E122D	Memory	One of the memory	Reseat the memory
	Regulator #	regulators has failed.	modules. See
	Failed.		"Troubleshooting System
	Reseat DIMMs.		Memory" on page 155.
E122E	On-board	One of the on-board	Remove AC power to the
	regulator	voltage regulators failed.	system for 10 seconds and
	failed. Call		restart the system.
	support.		If the problem persists,
			see "Getting Help" on
			page 177.
E1310	Fan ## RPM	RPM of fan is outside of	See "Troubleshooting
	exceeding	the intended operating	System Cooling Problems"
	range.	range.	on page 154.
	Check fan.

E1410 System Fatal	A fatal system error has
Error	been detected.
detected.

Check LCD for additional scrolling messages. Remove AC power to the system for 10 seconds and restart the system.

If the problem persists, see "Getting Help" on page 177.

28

About Your System