Dell T310 owner manual Removing an iDRAC6 Enterprise Card

Removing an iDRAC6 Enterprise Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized

in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is

not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2If present, disconnect the Ethernet cable from the iDRAC6 Enterprise Card connector on the system back panel. See Figure 1-3.

3Open the system. See "Opening the System" on page 85.

4Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer" on page 87.

5Remove the cooling shroud. See "Removing the Cooling Shroud" on page 88.

6Remove the VFlash media card (if installed) from the iDRAC6 Enterprise card.

7Pull back slightly on the two tabs at the front edge of the card and gently lift the front edge of the card off of the retention standoffs.

8As the card releases from the standoffs, the connector under the card disengages from the system board connector.Slide the card away from the back of the system until the RJ-45 connector is clear of the back panel, then lift the card out of the system.

9Replace the plastic filler plug over the port at the system back panel. "Back-Panel Features and Indicators" on page 19 for the port location.

10Replace the cooling shroud. See "Installing the Cooling Shroud" on page 89.

11Replace the expansion card stabilizer. See "Installing the Expansion Card Stabilizer" on page 87.

12Close the system. See "Closing the System" on page 86.

13Place the system upright on a flat surface.

14Reattach any peripherals and connect the system to an electrical outlet.

15Turn on the system and attached peripherals.

Installing System Components

123