Dell T310 owner manual Removing the Chassis Intrusion Switch

4Connect the battery cable to the connector on the storage card and replace the storage controller card. See "Installing an Expansion Card" on page 115.

5Replace the expansion card stabilizer. See "Installing the Expansion Card Stabilizer" on page 87.

6Close the system. See "Closing the System" on page 86.

7Place the system upright on a flat surface.

8Reattach any peripherals and connect the system to an electrical outlet.

9Turn on the system and attached peripherals.

Chassis Intrusion Switch

Removing the Chassis Intrusion Switch

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2Open the system. See "Opening the System" on page 85.

3Disconnect the chassis intrusion switch cable from the connector on the system board. See Figure 3-26.

4Slide the chassis intrusion switch out of the securing bracket notch.

134

Installing System Components