Dell T310 configuration settings in the, See Using the System Setup, Reseat the expansion cards

Table 1-3. System Messages (continued)

Message	Causes	Corrective Actions
No boot sector on	Incorrect configuration	Check the hard-drive
hard drive	settings in System Setup	configuration settings in the
	program, or no operating	System Setup program.
	system on hard drive.	See "Using the System Setup
		Program and UEFI Boot
		Manager" on page 57.
		If necessary, install the
		operating system on your
		hard drive. See your
		operating system
		documentation.
No timer tick	Faulty system board.	See "Getting Help" on
interrupt		page 177.
PCI BIOS failed	PCIe device BIOS (Option	Reseat the expansion card(s).
to install	ROM) checksum failure	Ensure that all appropriate
	detected during shadowing.	cables are securely connected
	Cables to expansion card(s)	to the expansion card(s).
		If the problem persists,
	loose; faulty or improperly
		see "Troubleshooting
	installed expansion card(s).
		Expansion Cards" on
		page 162.

PCIe Training Error: Expected Link Width is x, Actual Link Width is y.

Faulty or improperly installed PCIe card in the specified slot.

Reseat the PCIe card in the specified slot number.

See "Troubleshooting Expansion Cards" on page 162. If the problem persists, see "Getting Help" on page 177.

Plug & Play	Error encountered in	Install the NVRAM_CLR
Configuration	initializing PCIe device;	jumper in the clear position
Error	faulty system board.	(pins 1 and 3) and reboot the
		system. See Figure 6-1 for
		jumper location. If the
		problem persists,
		see "Troubleshooting
		Expansion Cards" on
		page 162.

46

About Your System