Dell W03C owner manual Replacing Memory Modules

1	memory-module connector	2 notch
3	securing clips (2)

Replacing Memory Module(s)

CAUTION: If the memory module is not installed properly, the computer may not boot.

1Follow the instructions in "Before You Begin" on page 11.

2Align the notch in the memory module with the tab in the memory- module connector.

Slide the memory module firmly into the slot at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear the click, remove the memory module and reinstall it.

3Place the memory-module shield on the system-board shield and snap the memory-module shield into place.

4Replace the back cover. See "Replacing the Back Cover" on page 21.

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

5Connect your computer and all attached devices to electrical outlets, and then turn them on.

6When the message appears stating that memory size has changed, press <F1> to continue.

7Log on to your computer.

To verify that the memory is installed correctly, click Start	→ Control
Panel→ System and Security→ System.

Check the amount of memory (RAM) listed.

Memory Module(s)

33