21

Antenna-In Connector

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

Removing the Antenna-In Connector

1Follow the instructions in "Before You Begin" on page 11.

2Remove the back cover. See "Removing the Back Cover" on page 19.

3Remove the rear-stand assembly. See "Removing the Rear-Stand Assembly" on page 35.

4Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.

5Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.

6Remove the system-board shield. See "Removing the System-Board Shield" on page 53.

7Remove the two screws that secure the antenna-in connector to the chassis.

8Disconnect the antenna-in cable from the connector on the Mini-Card.

9Slide and lift the antenna-in connector along with its cable away from the chassis.

Antenna-In Connector

89

Page 89
Image 89
Dell W03C owner manual Removing the Antenna-In Connector