INSTALLATION OF YOUR DYNASTY GRILL

(continued)

installation

Leak Testing

Perform a leak test at least once each year whether the gas supply cylinder has been disconnected or not. In addition, anytime the gas cylinder is connected to the regulator or any part of the gas system is disconnected or replaced, conduct the leak testing. This applies to natural gas as well as propane gas. As a safety precaution, remember to always leak test your grill outdoors in a well ventilated area. Never smoke or permit sources of ignition in the area while doing a leak test. Do not use a flame, such as a lighted match, to test for leaks. Use only a leak testing solution as specified below.

Leak Testing Procedure

1.Prepare a leak testing solution of sudsy water by mixing in a spray bottle half liquid soap and half water.

2.Check and make sure all the control knobs are in the OFF position.

3.Turn cylinder valve knob counter clockwise one turn to open.

4.Apply leak-testing solution by spraying on joints of the gas delivery system.

5.Blowing bubbles in the soap solution indicates that a leak is present.

6.Stop a leak by tightening the loose joint or by replacing the faulty part with a replacement part recommended by the manufacturer. Do not attempt to repair the cylinder valve if it should become damaged. The cylinder must be replaced.

(continued next page)

13

Installation

Page 13
Image 13
Dynasty Stoves DOBB4203A, DOPB3003A, DOBQ3000A, DOBB3003A, DOBQ4200A, DOBB1803A manual Leak Testing Procedure