INSTALLATION OF YOUR DYNASTY GRILL

installation

Safe and satisfactory operation of your Dynasty grill depends upon its proper installation. The installation, adjustments and service of your Dynasty grill must be performed only by

qualified installers and service technicians. This is necessary to insure proper operation and also to prevent accidents.

Location

When determining a suitable location take into account concerns such as exposure to wind, proximity to traffic paths and keeping any gas supply lines as short as possible. Locate the grill only in a well ventilated area. For free standing models allow 12" from the sides and rear to adjacent combustible construction.

Built-in Installation

Your Dynasty grill is designed for easy installation into a non-combustible enclosure.

The supporting deck and counter must be level and flat. When determining the final location for your grill it is required that ventilation holes be provided in the enclosure so that gas will not become trapped in the event of a leak (See page 9).

When installing your Dynasty grill in a combustible enclosure, it is necessary to use a suitable insulated jacket or sleeve; follow cabinet cut out dimensions as shown on page 7. Use only an insulated jacket or sleeve manufactured by Jenn-Air.

Built-in Design Models

If using a rear wall, locate the weather proof electrical outlet on the left-hand side for the rotisserie motor. The rotisserie motor requires a 110/120 VAC supply. The power supply cord on the motor is equipped with a 3 prong (grounded) plug for protection against shock hazard. Do not cut or remove the grounding prong from the plug.

NOTE: See dimension tables in page 7 referring to figure below. When installing a grill, side burner, or bartender on a cabinet with bullnose, dimension "A" is the width of appliance plus 1/8 clearance.

4 X 4 MIN. OPENING FOR

4 X 4 MIN. OPENING FOR

REAR GAS CONNECTION

BOTTOM GAS CONNECTION

3 PRONG PLUG

6

Page 6
Image 6
Dynasty Stoves DOPB3003A manual Installation of Your Dynasty Grill, Location, Built-in Installation, Built-in Design Models