When you change the Ping Speed to any setting greater than 50 percent, the unit automatically enters HyperScroll mode.
These faster ping rates allow you to maintain a
When using HyperScroll, you may also need to manually decrease the sensitivity for optimum performance. Depending on water depth and other conditions, HyperScroll may cause a second bottom echo to return to the transducer during the next ping cycle. This can result in a large amount of clutter appearing on the screen. If this occurs, just decrease the sensitivity to a level that eliminates the clutter. When you turn HyperScroll off, you can return to your original sensitivity level.
Sonar Menu with Ping Speed command selected (left). The Ping Speed Control Bar (right) at default setting.
To change Ping Speed:
1.From the Sonar Page, press MENU↓ to PING SPEEDENT.
2.The Ping Speed Control Bar appears. Press ↑ to increase ping speed or ↓ to decrease ping speed. When it's set at the desired level, press EXIT.
When you boost ping speed and switch into HyperScroll, the width of the FasTrack bar graph display doubles at the right side of the screen. This allows you to see virtually instantaneous sonar returns, just as you would on a flasher sonar unit. For more information on FasTrack, see its entry in this section.
To turn off HyperScroll:
1.From the Sonar Page, press MENU↓ to PING SPEEDENT.
2.The Ping Speed Control Bar appears. Use ↓ to decrease ping speed to
50percent and press EXIT.
71
