Use the mouse to click blocks on the grid pattern to assign the areas you wishes EdiView to detect / ignore motion. EdiView will detect motion for areas which are NOT covered by blocks only.
To add or erase blocks:
To add blocks, click + button; to erase blocks, click- button. Click ‘Reset’ button to reset motion detection blocks to default setting. You can also change the color of block if its color is similar to the IP camera’s video and makes you hard to identify the blocks by click the color brick between + and - button:
Drag red, green, and blue slide bar to set color, and click ‘Set’ button to save changes, click ‘Default’ button to reset settings, and click ‘Cancel’ to leave this menu without saving changes.
You also have to setup sensitivity:
79
