Setting the Initial Switch Configuration

Configuring the IP Address

The Departmental Switch DS-16B2 switch is shipped with a default

IP address of 10.77.77.77.

To change the default IP Address and configure the Fibre Channel IP address of the switch:

1.Login to the switch as the admin user.

2.At the command line, enter the following command: ipAddrSet

3.An interactive session opens and prompts you for configuration values.

a.Press ENTER without entering a value to skip over a prompt and leave the parameter value as the default.

b.At the Ethernet IP Address prompt, enter the new IP address for the Ethernet port on the switch. Press ENTER to continue.

c.At the Ethernet Subnetmask prompt, enter the address of the subnetmask, if applicable. Press ENTER to continue.

d.At the Gateway Address prompt, enter the IP address of the gateway system if applicable. Press ENTER to continue.

e.The configuration is then committed to the switch firmware.

f.You are then prompted whether to make the IP address changes active now or at the next reboot. Enter y at the prompt to have the IP address changes take effect immediately.

Configuring the IP Address

1-5

 

 

1

Page 15
Image 15
EMC DS-16B2 manual Configuring the IP Address