|
|
|
|
| Configuring an EMC Boot Device |
|
|
|
|
|
|
|
|
|
|
|
|
| Installing the |
| Follow the appropriate steps below to install the Windows operating | ||
| Windows OS onto |
| system onto the EMC boot device. | ||
| the Boot Device |
|
|
|
|
| Windows NT |
|
|
|
|
|
| Microsoft does not provide a driver for the QLogic controllers on the | |||
|
|
| Windows NT installation | ||
|
|
| on a the EMC storage array boot device connected to a QLogic controller, the | ||
|
|
| Windows installation diskettes must be used with the | ||
|
|
|
|
|
|
|
|
| 1. Boot the server with Windows NT installation diskette 1. The | ||
|
|
| server displays the following message, followed by a blank blue | ||
|
|
| screen. Press F6 as soon as the blue screen appears: | ||
Setup is inspecting your computer's hardware configuration
Pressing F6 tells the Windows installer that you want to load a
2.Follow the prompts to insert the necessary diskettes until the setup stops to allow you to add additional devices.
A screen message will tell you that the setup program cannot determine the type of one or more mass storage devices.
From this point, press S to specify additional devices. You will need to select
Other and press ENTER.
3.Insert the QLogic driver disk into the diskette drive and press
ENTER.
4.You are prompted to select one of four driver choices. Select QLogic QLA2300 (or QLA2200) PCI Fibre Channel Adapter and press ENTER.
The driver loads and you are brought back to the Additional Devices screen.
5.You must now load the driver for your
Press S to specify an additional device.
6.From the list, scroll up to select IDE
Configuring a Symmetrix Boot Device | |
|
|
3
