EMC QLA22xx, QLA23xx manual Note these prerequisites RDP server with release

HP ProLiant BL20p G2

Windows 2000

Installation

Configuring an EMC Boot Device

1.Note these prerequisites:

•RDP server with release 1.30

•BfS Installation script, see HP ProLiant BL20p G2 documentation for creation and installation of this script.

2.Configure BL20p G2. Then reboot the BL20p G2 and select F9 to RBSU (F10 to save all changes before exit).

a. Select Set Boot Controller Order

i.Ctrl:1 PCI Dual Port Fibre..Port 1

ii.Ctrl:2 PCI Dual Port Fibre..Port 2

iii.Ctrl:3 HP Smart Array 5i Ctrl

b.Set IPL order as follows:

i.PCI Embedded HP NC7781 Gig Server Adapter Port 1

ii.CD-ROM

iii.Floppy Drive

iv.Hard Drive C:

3.Install the Windows 2000 OS:

a.If there is a local hard drive installed, remove it. This drive can be reinserted after the installation is completed.

b.Open an interface window using the RDP console by Right-clicking the target server and selecting Power Control/ RILOE Interface.

c.Delete the target server (BfS Server) from the RDP database if it exists.

d.Reboot the BfS server. (At boot time, the newly created LUN should be detected.)

The BfS server should now be seen in the RDP New Computer pane.

e.Start the BfS deployment by dragging and dropping the BOOT FROM SAN BL20p script task to the BfS server new computer

Installation time is approximately 50 minutes.

3

Configuring a Symmetrix Boot Device 3-9