Configuring an EMC Boot Device
register the HBA connection. If you will later install PowerPath or ATF, be sure to select the corresponding parameters during the registration procedure. Refer to your EMC ControlCenter Navisphere Management software, ATF, or PowerPath documentation for detailed instructions.
6.Press ESC until you exit the Fast!UTIL Options menu. You do not need to save any changes if prompted.
7.Reboot the server.
When the QLogic BIOS banner (shown in step 1) appears, press
Different HBA models may display different banners. Be sure to select
8.After Fast!UTIL loads, the display depends on whether there are multiple QLogic HBAs installed:
•If there is only one QLogic HBA, the Fast!UTIL Options menu appears.
•If there are multiple QLogic HBAs, a list of addresses occupies by those HBAs appears. Use the arrow keys to select the desired HBA; then press ENTER. The Fast!UTIL Options menu appears.
9.Select Configuration Settings from the menu.
10.Select Selectable Boot Settings from the Configuration Settings menu.
Select the first Boot Port Name entry, and in the Device window select the CLARiiON port WWN from which you want to boot.
After you select the WWN, if there is more than one LUN detected, select the boot LUN number from the next window.
11.When all parameters are set correctly, press ESC to return to the Fast!UTIL Options menu; then select Save Changes to save the changes you made to the current adapter.
12.Press ESC to exit the Fast!UTIL Options menu.
13.Reboot the server.
What Next? Install Windows as described in the next section.
Configuring a CLARiiON Boot Device | |
|
|
3
