![](/images/new-backgrounds/1172471/17247155x1.webp)
Hardware Preparation and Installation | Configuring the Module |
|
|
2.3Configuring the Module
The module provides the configuration switch SW1 as shown in the following figure. The switch settings shown in the figure correspond to the default settings. The switches are displayed as the small white squares.
Figure 2-1 Switch Location
Product Malfunction
Switches marked as 'reserved' might carry
Therefore, do not change settings of switches marked as 'reserved'. The setting of switches which are not marked as 'reserved' has to be checked and changed before product installation.
Product Damage
Setting/resetting the switches during operation can cause product damage. Therefore, check and change switch settings before you install the product.
28 |