Emerson PMC-CGM manual Event Codes and Severity, MIB DescriptioncgmSys, Code Severity Description

MIB DescriptioncgmSys

Table 5-6 cgmEventTable (continued)

OID	MIB Object	Description	Access
.1.3.1.1.4	cgmEventCode	A pre-defined event code - for details refer to Table 5-7 on	r
		page 56.
.1.3.1.1.5	cgmEventData	Event specific data	r
.1.3.1.1.6	cgmEventDescr	Textual event description	r

The following table lists all event codes and their severity. Events which cause the module to give up mastership are marked with an asterisk in the "severity" column.

Table 5-7 Event Codes and Severity

Code	Severity	Description
inputChanged (1)	Event	The selected PLL input has changed.
lostLock (2)	Event	The T0 PLL lost lock and enters holdover mode.
gainedLock (3)	Event	The PLL gained lock.
nowMaster (4)	Event	The module has acquired mastership.
nowSlave (5)	Event	The module has entered slave mode.
validInputsChanged (6)	Event	The validity or more of the PLL inputs has changed .
selectedInputFailed (7)	Event	The selected clock input has failed.
dpllInitError (10)	Warning	Error while initializing the DPLL.
freqValidationError( 11)	Warning	One of the clock sources measured in the FPGA is out
		of range.
inputStateChange (12)	Event	Reported when a state change is detected by the
		activity monitor.
		EventData: Upper 16 bits encode the new state, lower
		16 bits encode the input number.
		State can be
		0 (working)
		1 (failing)
		2 (failed)
		3 (recovering)
		4 (unknown)
		This is the same information as presented in the
		cgmInputActivityMonitor element.
lineCardClkError (20)	Warning	Not applicable for PMC-CGM.
lineCardClkSelected (21)	Event	Not applicable for PMC-CGM.
bitsRlof/c (30/34)	Event	"Loss of frame" / "Loss of frame cleared" event
		detected on a BITS interface.
		EventData: The BITS interface on which the event has
		been detected (0 or 1).

56 PMC-CGM Installation and Use (6806800D53C)