7.To replace the front panel, fit the three ridged tabs on its bottom edge into the three notches on the lower edge of the computer, as shown below.

notches

tabs

8.Tilt up the front panel until the clips on the top touch the computer. Then push on the top of the panel until it clicks into place. Your diskette drive(s) should be flush with the front of the panel.

9.Follow the steps on page 5-41 to replace the computer’s cover. Then see “Post-installation Setup” later in Chapter 5 for instructions on configuring your computer for use with your new hard disk drive.

Note

After you change your computer’s drive configuration, the computer may take several minutes to complete power-on diagnostics the next time you turn it on.

Installing and Removing Disk Drives

B-23