You can stop testing at any time and return to the main menu by holding down Ctrl and pressing Break. The program completes the current test before it stops.
You must enter certain parameters to run the hard disk and diskette drive tests. If you use F3 to select these tests, the program prompts you for the parameters immediately. If you use F4, the program prompts you for the parameters during the first pass of the test. If you perform the tests more than once, the program uses the same parameters for each pass.
If you selected Passbound testing, the program displays the pass number on the right side of the screen above the Run time parameters window. For example:
Pass : 00001
If you entered Y at the Wait on error prompt, the program pauses if an error occurs. When you press Enter, the program continues testing.
Note
Tests selected using the F3 and F4 keys remain selected until you cancel the selection. Be sure to press F5 to cancel all selections when you are finished running each set of tests.
Performing System Diagnostics |