3.To run the program, press Y. To exit without running CORFIX, press N. If you press Y, you see the MS-DOS prompt and this message:

Configuration completed. The SMART installation utility may now be used.

4.Use the SMART setup program now. See your RampagePlus 286+ manual for instructions.

Post-installation Setup

After you install or remove options such as memory modules, a math coprocessor, or a disk drive, you need to run the SETUP program to update the computer’s configuration information.

For example, if you add a hard disk drive, you need to let the computer know the type of drive you have installed. See Chapter 2 for instructions.

If you replaced the battery for the real-time clock and CMOS RAM, you must run SETUP to reconfigure your system and reset the clock. See Chapter 2.

N o t e

If you installed additional extended memory and want to use any of it as expanded memory, see “Using Expanded Memory Beyond 1MB" in Chapter 4 for instructions.

If you install a hard disk drive that has never received a hardware level format (such as some non-Epson hard disk drives), you need to format the disk. Check the manual that came with your drive, and then, if necessary, follow the instructions in Appendix C to format your new hard disk.

5-44 Installing and Removing Options