LI If you want to use any of the memory on your card as

expanded memory, see “Using Expanded Memory Beyond 1MB” in Chapter 4.

Also see “Post-installation Setup,” below, for more information on setting up your computer for use with an option card.

Using the CORFIX Program

To configure your computer for use with the Rampage Plus 286+ memory card, you need to run CORFIX, an Epson utility on your Reference diskette, and SMART, the Rampage Plus 286+ setup program. You must run CORFIX before you use SMART.

If you have a hard disk, you can copy CORFIX.EXE from your Reference diskette to your hard disk before you run it. Then follow these instructions to run CORFIX:

1.Turn on your computer. Make sure the MS-DOS command prompt appears on the screen. If you do not have a hard disk (or you did not copy CORFIX to your hard disk), insert your Reference diskette in drive A. Type A: and press Enter to log onto drive A.

2.At the MS-DOS prompt, type CORFIX and press Enter. The following messages appear:

The program will configure the system to work with the SMART utility when installing the Rampage plus 286.

SMART can only be executed immediately after this configuration program. Continue ? (Y/N)

Installing and Removing Options 5-43