9.Now locate the hard disk drive ribbon cable. Pull the cable over toward the socket and fold it so the tab and notch are aligned. Then connect it in the same manner as the diskette drive cable.

10.To replace the front panel, fit the three ridged tabs on its bottom edge into the three notches on the lower edge of the computer, as shown below.

notches

tabs

11.Tilt up the front panel until the clips on the top of the panel touch the computer. Then push on the top of the panel until it clicks into place. The diskette drive(s) should be flush with the front panel.

(If you removed the slot cover, be sure to store it in a safe place in case you need to replace it later.)

12.Follow the steps on page 5-41 to replace the computer’s cover. Then see “Post-installation Setup” later in Chapter 5 for instructions on configuring your computer for use with your new disk drive configuration.

Installing and Removing Disk Drives

B-55