Wiring the network cable
The cable can be terminated as either a patch cable or a crossover cable (see figure 9) and must be properly terminated for your application:
•Patch (straight) cable — Connection of the ISM to an Ethernet hub, router, or switcher that also hosts a controlling computer
•Crossover cable — Direct connection between the ISM and a controlling computer
Pins:
12345678
Insert Twisted
Pair Wires
RJ-45
Connector
Crossover Cable
| End 1 | End 2 |
Pin | Wire color | Wire color |
|
|
|
1 | ||
2 | Green | Orange |
3 | ||
4 | Blue | Blue |
5 | ||
6 | Orange | Green |
7 | ||
8 | Brown | Brown |
|
|
|
| T568A | T568B |
A cable that is wired as T568A at one end and T568B at the other (Tx and Rx pairs reversed) is a "crossover" cable.
Pin | End 1 | End 2 |
Wire color | Wire color | |
|
|
|
1 | ||
2 | Orange | Orange |
3 | ||
4 | Blue | Blue |
5 | ||
6 | Green | Green |
7 | ||
8 | Brown | Brown |
|
|
|
T568BT568B
A cable that is wired the same at both ends is called a
Figure 9. RJ-45 Connector Pinout Tables
RS-232 Connection
HRemote port — Connect a host device, such as a computer or touch panel control, to the integration scaling matrix switcher via this
Pin |
| Function | 5 | 1 | |
1 | — | Not used | |||
|
| ||||
2 | TX | Transmit data |
|
| |
3 | RX | Receive data | 9 | 6 | |
4 | — | Not used | |||
Female | |||||
5 | Gnd | Signal ground | 1 | 5 | |
6 | — | Not used | |||
7 | — | Not used |
|
| |
8 | — | Not used | 6 | 9 | |
9 | — | Not used | |||
Male | |||||
|
|
| |||
Figure 10. Remote Port Pin Assignments
See Programming Guide on page 31, for definitions of the SIS commands and
Switcher Software on page 47, to install and use the control software.
Configuration
The ISM can be configured using either the front panel controls, the SIS, or the Windows Control program (see the Operation section on page 16, the Programming Guide section on page 38, the Switcher Software section on page 49, and the HTML Operation section on page 60
