Extron electronic MGP 464 DI Preliminary, Operation, cont’d, Resolution and Refresh Rate submenu

PRELIMINARY

Operation, cont’d

Resolution and Refresh Rate submenu

While this submenu is displayed, rotate the horizontal Adjust ([) knob to select one of the available resolutions, or rotate the vertical Adjust ({) knob to select one of the available refresh rates. The resolutions and refresh rates are listed in the following table.

Resolution			Refresh Rates
	50 Hz	60 Hz	72 Hz	96 Hz	100 Hz	120 Hz
640 x 480	X	X	X	X	X	X
800 x 600	X	X	X	X	X	X
852 x 480	X	X	X	X	X
1024 x 768	X	X	X	X
1024 x 852	X	X	X	X
1024 x 1024	X	X	X
1280 x 768	X	X
1280 x 1024	X	X
1360 x 765	X	X
1365 x 768	X	X
1366 x 768	X	X
1365 x 1024	X	X
1400 x 1050	X	X
1600 x 1200	X	X
480p		X
576p	X
720p	X	X
1080i	X	X
1080p	X	X
DVI BCKGD* RATE	Resolution and clock of the incoming background input

*When DVI BCKGD is selected as the output resolution/rate, the MGP uses the incoming DVI background input resolution and clock as the output rate. The sync type and polarity options are available for the RGB output while the background timings are used. If available, the output of the MGP is locked to the DVI background rate until you select a different resolution or disconnect the DVI background input.

The resolution provided in the Extended Display Identification Data (EDID) is the last selected factory rate. To set the resolution information provided in the EDID data, set the output resolution on the MGP to the desired factory resolution, then select DVI BCKGD RATE from the front panel menu.

Output Type submenu

Rotate either the horizontal Adjust ([) or the vertical Adjust ({) knob to select the output signal type required by the display device. Available signal types are RGBHV, RGBS, YUV bi-level and YUV tri-level. The default is RGBHV.

3-12 MGP 464 • Operation