Extron electronic MGP 464 DI manual Preliminary, LAN port defaults, MGP 464 Installation

Use a straight-through cable to connect to a network, or a crossover cable to connect directly to a computer.

•For 10BaseT (10 Mbps) networks, use a Cat 3 or better cable.

•For 100BaseT (max. 155 Mbps) networks, use a Cat 5 cable.

RJ-45 connector

Pins:

12 3 4 5 6 7 8

Side View

Insert

twisted pair wires.

Straight-through Cable

(for connection to a switch, hub, or router)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-orange
2	orange	2	orange
3	white-green	3	white-green
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	green
7	white-brown	7	white-brown
8	brown	8	brown

Crossover Cable

(for direct connection to a PC)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-green
2	orange	2	green
3	white-green	3	white-orange
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	orange
7	white-brown	7	white-brown
8	brown	8	brown

PRELIMINARY

You must also configure the LAN port before using it. You can do this by using SIS commands (see “Command/response table for SIS commands” in chapter 4, “Software Configuration and Control”) or by using the Comm./IP Configuration menu on the front panel (see “Comm./IP Configuration menu” in chapter 3, “Operation”).

LAN port defaults:

•MGP’s IP address: 192.168.254.254

•Gateway IP address: 0.0.0.0

•Subnet mask: 255.255.0.0

•DHCP: off

5Reset button — Pressing this recessed button causes various IP functions and

Ethernet connection settings to be reset to the factory defaults.

6Reset LED — This green LED, located to the upper-right of the reset button, blinks a varying number of times to indicate which reset mode has been entered. See “Resetting the unit” in chapter 3, “Operation,” for details.

MGP 464 • Installation 2-7