Firmware Upgrade | Extron electronic MVX PLUS 128 specs

HTML Operation, cont’d

Email address ﬁelds

The eight Email address ﬁelds identify the e-mail addresses of the personnel to whom the MVX 128 switcher e-mails notiﬁcation of its failure and repair status. Standard e-mail address conventions (nnnnn@xxx.com) apply.

The check boxes and drop boxes associated with each address ﬁeld permit the operator to specify speciﬁc criteria under which the switcher will e-mail recipients. In the associated Missing Input drop boxes, select the inputs to monitor for presence or absence of a signal. Check the Fans and Power boxes to monitor the cooling and power supplies. In the associated E-Mail Options drop box, select whether the recipient is to be e-mailed of failures, ﬁxes, both, not notiﬁed, or to be removed from the e-mail list. The Suspend option is useful for temporarily removing personnel from the e-mail list when they are unavailable, such as on travel or vacation. Deleting an e-mail addressee and clicking the submit button removes the recipient from e-mail notiﬁcation completely.

Firmware Upgrade page

The Firmware Upgrade page provides a way to replace the ﬁrmware that is coded on the switcher’s control board without taking the switcher out of service, opening the switcher enclosure, and replacing the ﬁrmware chip. Access the Firmware Upgrade page (ﬁgure 6-8) by clicking the Firmware Upgrade link on the System Conﬁguration page.

Select System Configuration.

Select Email Settings.

Refresh.

Figure 6-8 — Firmware Upgrade page

Update the switcher ﬁrmware as follows:

NThe Firmware Upgrade page is only for replacing the ﬁrmware that controls all switcher operation. To insert your own HTML pages, see File Management Page, on page 6-11.

1. Visit the Extron web site, www.extron.com, select the CrossPoint/MAV Plus product category, select the latest ﬁrmware installation package (*.exe ﬁle) for the switcher, and download the ﬁle. Note the folder to which you save the ﬁrmware ﬁle.

6-10 MVX Plus 128 VGA Matrix Switchers • HTML Operation

Image 118

Extron electronic MVX PLUS 128 manual Firmware Upgrade, Email address ﬁelds

Contents

VGA Matrix Switchers MVX Plus Sicherheitsanleitungen Deutsch Safety Instructions EnglishConsignes de Sécurité Français Instrucciones de seguridad Español Plug the switcher into a grounded AC source MVX Plus 128 VGA Matrix Switchers Quick Start QS-1 QS-2 MVX Plus 128 VGA Matrix Switchers Quick Start Saing or recalling a presetViewing and adjusting the audio level Create a tie Table of Contents Table of Contents, cont’d MVX Plus 128 VGA Matrix Switchers Table of Contents Iii Iv MVX Plus 128 VGA Matrix Switchers Table of Contents Appendix B Speciﬁcations, Part Numbers, Accessories Vi MVX Plus 128 VGA Matrix Switchers Table of Contents One MVX Plus 128 VGA Matrix Switchers Introduction About the Matrix SwitchersAbout this Manual Deﬁnitions Features Introduction, cont’d Tie any input to any or all outputs Introduction, cont’d Two Cabling and Rear Panel Views Mounting the SwitcherMVX Plus 128 VGA Matrix Switchers Installation Video connections Captive screw connector wiring for audio inputs Audio connections Installation, cont’d RS-232/RS-422 connection Cabling and RJ-45 connector wiring To control the networked switcher with SIS commands fromProgram or has downloaded Html pages from the switcher Ethernet connection Reset button Power connection Three MVX Plus 128 VGA Matrix Switchers Operation Front Panel Controls and IndicatorsDeﬁnitions Input and output buttons Control buttons Operation, cont’d Controls Button icons Sample button icons Front Panel Operations PowerCreating a conﬁguration Press and release the Esc button ﬁgure Example 1 Creating a set of video and audio tiesPress and release the input 5 button ﬁgure Press and release the Enter button ﬁgure All input buttons and output buttons Example 2 Adding a tie to a set of video and audio ties Press and release the output 1 button ﬁgure 13 Press the Enter button Example 3 Removing a tie from a set of video and audio ties Press and release the output 4 button ﬁgure Current conﬁguration ﬁgure 3-20 is now Video Viewing a conﬁguration Lights red Rgbhv button and the Audio button ﬁgure Press and release the Rgbhv button to deselect Rgbhv ﬁgure Red Grouping 27 I/O grouping of incompatible video formats Operation, cont’d Example 5 Grouping inputs and outputs Press and release the Enter button to select group 1 ﬁgure Press and release the Preset button to select group 2 ﬁgure 32 Select an I/O group Setting RGB delay Example 6 Setting the RGB delay for an output 35 Select RGB Delay mode Press and release the output 17 button ﬁgure Using presets Press and release the Rgbhv button ﬁgure Example 7 Saving a preset ﬁgure Example 8 Recalling a preset Press and release the Preset button ﬁgure Muting and unmuting video and/or audio outputs 47 Press the Enter button Example 9 Muting and unmuting an output Release the Rgbhv button and the Audio button ﬁgure 50 Mute the outputs Audio level Viewing and adjusting the input audio levelTo blink red, then release the button Stops blinking Example 10 Viewing and adjusting an input audio level 54 Clear all selections Input audio level adjustment displays 3 F 4 Press and release the Audio button ﬁgure Viewing and adjusting the output volumeAudio volume Audio mode. The Audio button stops blinking Reading the displayed volume Audio volume adjustment settings Example 11 Viewing and adjusting an output volume level 10 11 3 4 5 6 7 F 8 9 10 11 Locking out the front panel Executive mode Performing a system reset from the front panel Background illumination 66 Toggle background illumination on or off Selecting the RS-232/RS-422 protocol and baud rate Serial protocol Performing soft system resets Rear Panel Controls 70 Whole switcher and absolute resets To the switcher ﬁgure Performing a hard resetIf necessary, turn off power to the switcher Optimizing the Audio Conﬁguration Worksheets TroubleshootingWorksheet example 1 System equipment Worksheet example 2 Daily conﬁguration 73 Worksheet example 2 Daily conﬁguration Worksheet example 3 Test conﬁguration 74 Worksheet example 3 Test conﬁguration Output destinations Conﬁguration worksheet Operation, cont’d Four MVX Plus 128 VGA Matrix Switchers Programmer’s Guide RS-232/RS-422 Link Default IP addresses Ethernet Link Host-to-Switcher Instructions Switcher-Initiated Messages Switcher Error Responses Using the Command/Response Tables Command/Response Table for SIS Commands Symbol deﬁnitions Command Ascii command Response Additional Description % G InX! AudX$ Value Output Attenuation Volume EX11X12...X112O EX*MR EZG EVM EDF X1-X2-X2 Command/Response Table for IP SIS Commands X5# Command/response table for IP SIS commands Special Characters Example Response description Five Ethernet protocol settings Matrix Switchers Control ProgramInstalling the software MVX Plus 128 VGA Matrix Switchers Matrix Software Using the software Comm port selection window Matrix Software, cont’d Extron Matrix Switcher+ Control Program window blank IP Settings/Options window Control program IP setting/options window Matrix IP Address ﬁeld Extron Name/Descriptor ﬁeld Hardware Address ﬁeld Gateway IP address ﬁeldSubnet Mask ﬁeld Use Dhcp checkbox GMT offset ﬁeld Time local ﬁeldSync Time to PC button Use Daylight Savings checkbox Administrator Password ﬁeld User Password ﬁeld Mail Server IP Address ﬁeld Mail Server Password ﬁeldMail Server Domain Name ﬁeld Miles Standish Mail Addressee ﬁelds Download. Note the folder to which you save the ﬁrmware ﬁle Updating ﬁrmwareRun the executable *.exe ﬁle to decompress the ﬁrmware ﬁle Uploading Html ﬁles Windows menus Windows buttons, drop boxes, and trashcanFile menu Tools menu Status window Preferences menu 10 Ties shown as lines 11 Ties shown as crosspoints Using the help system Using emulation modeMaster-Reset selection Button-Label Generator Program 12 Extron’s Button-Label Generator window Html Operation MVX Plus 128 VGA Matrix Switchers Html Operation Access the switcher using Html pages as followsPassword. Click the OK button Download the Startup System Status System Status Html Operation, cont’d Dsvp System Conﬁguration System Conﬁguration Dhcp radio buttons IP Settings ﬁeldsUnit Name ﬁeld IP Address ﬁeld Savings time feature Date/Time Settings ﬁeldsClick the Submit button Passwords Passwords Mail IP Address ﬁeld Email SettingsDomain Name ﬁeld Firmware Upgrade Email address ﬁelds File Management Click the Browse button Set and View TiesUpload your own ﬁles as follows Browse through your system and select the desired ﬁles RGB and Audio Settings Creating a tie Click the desired input Changing the input gain and attenuationButton until the desired input is visible Click the desired gain or attenuation value Button until the desired output is visible Muting and unmuting one or all outputsMute one or all outputs as follows Click the desired output Changing the RGB delay Click the desired RGB delay Changing the output volume level Click the desired output volume step value Number Output Steps Attenuation Volume Saving a preset Global PresetsRecalling a preset Special Characters AAppendix a Default address MVX Plus 128 VGA Matrix Switchers Ethernet Connection Pinging to determine Extron IP address MVX Plus 128 VGA Matrix Switchers Ethernet Connection A-3Pinging to determine Web IP address Telnet tips Connecting as a Telnet clientOpen Local echo MVX Plus 128 VGA Matrix Switchers Ethernet Connection A-5Escape character and Esc key Set carriage return-line feed Local and remote devices Subnetting a PrimerGateways IP addresses and octets MVX Plus 128 VGA Matrix Switchers Ethernet Connection A-7 Determining whether devices are on the same subnet Ethernet Connection, cont’d AppendixBB Speciﬁcations, Part Numbers, Accessories Speciﬁcations Audio Speciﬁcations, Part Numbers, Accessories, cont’d Included parts Replacement part Number Part Numbers and AccessoriesAccessories Adapters, power supplies, labels Part number Male-to-male VGA molded connector cables Part number Male-to-female VGA molded connector cables Part numberMale-to-female VGA backshell connector cables Part number Cables Installing labels in the matrix switcher’s buttons Button Labels Speciﬁcations, Part Numbers, Accessories, cont’d Button label blanks Speciﬁcations, Part Numbers, Accessories, cont’d FCC Class a Notice Extron’s Warranty Extron Electronics, Europe Extron Electronics, USA