Installation

Surface Mounting With Screws

The SXRC Control Head can also be surface mounted if you do not have a spare DIN opening in your dash or do not want to cut one into an existing panel.

The back of the SXRC Control Head has two metal inserts designed to work with M3 screws.

Center to Center

5-17/32" (140mm)

Inserts for M3 Screws

Find a suitable location and drill two 1/8 inch (3 mm) holes to secure the SXRC Control Head.The holes should be 5-17/32” (140 mm) apart from center to center.

NOTE: You will need to have access to the area behind this location to install the mounting screws.

Mounting Surface

Center to Center

5-17/32" (140mm)

Once your holes are drilled you can use the two supplied M3 screws to secure the SXRC Control Head to your mounting surface. If the supplied screws are not long enough to reach the SXRC Control Head you can supply your own M3 screws of the required length to secure the SXRC.

Mounting Surface

NOTE!!! Whether using the supplied M3 screws from the SXRC kit or your own, the screws can not enter into the SXRC more than 5/16” (4 mm). If you attempt to insert the screw any deeper than this into the SXRC Control Head you will run the risk of damaging the unit.

NO MORE THAN 5/16" (4 mm)

Mounting Surface

Route the SXRC Control Head cable to your SXRC Interface Box location.Your SXRC Control Head is now mounted and you can move on to the wiring section of this manual.

Mounting Surface

10

SXRC Remote Control

Page 10
Image 10
Fortinet 2 SXRC manual Surface Mounting With Screws