Fortinet 2 SXRC manual Standard DIN sized opening, Be sure you will have a minimum

Installation		Mounting
	DIN Mounting
	Using the supplied hardware you can mount the SXRC into a
	standard DIN sized opening.
		7-3/16"
	Mounting	182 mm
	Surface
	2"

Using the existing DIN opening or the one you just created, slide the Metal DIN Mounting Cage into the opening. Secure the Cage by bending the Mounting Tabs on the sides, top and bottom of the Cage using a small flat-blade screwdriver. Use only the tabs that when bent will secure the Cage to the Mounting Surface.

SMAC-
ON	TOOLZ

Mounting

Surface

Mounting

Tabs

51 mm

53mm 21/8"-

Be sure you will have a minimum of 2”

SMAC-
ON	TOOLZ

Side View

(51 mm) clearance depth behind your mounting

Other surface panel to mount the SXRC.

Surfaces

If not using an existing DIN opening, you will first need to cut an opening that is 7-3/16” (182 mm) by 2-1/8” (53 mm) into your mounting surface panel.

7-3/16"

182 mm

53 mm 2-1/8"

It is VERY important that you DO NOT make the hole any larger than the specified dimensions. If you make the opening too large then the mounting cage will not work properly.

Mounting

Surface

Mounting	Top and Bottom View
Tabs

Next, place the Plastic Cosmetic Trim Ring into the Metal DIN Mounting cage. There are two plastic retainers in the Trim Ring (one on top and one on bottom) that will snap into place.

Plastic Cosmetic Trim Ring

Mounting

Surface

Metal DIN Mounting Cage

8 SXRC Remote Control