Fortinet 2 SXRC manual Press the ENT key to enter the Main, Menu of the amplifier, Default Menu

The important thing is that no matter what combination of amplifiers you are running, each amplifier must have its own unique Remote Address.

It is also a good idea to write down which amplifier has been assigned which address. This will help you later in identifying the amplifier and assigning it a name based on its function. For

example: BASS AMP 1, BASS AMP 2, FRONTSTAGE, MIDBASS,

etc. A fill-in-the-blank form is provided in the back of this manual to assist you.

Step 2.) Power up your system so you can access the settings and controls of your SX Series amplifiers. When the amplifiers power up you will see * KICKER *. You are now in the amplifiers Default Screen.

Step 8.) Power cycle your system by turning it off, waiting 3 seconds, then turning it back on.

NOTE:

At this point each SX Series amplifier has been assigned a unique Remote Address. Be sure you have properly done this to each amplifier before proceeding! If multiple amplifiers share the same address, they all will be detected and you will corrupt the software that is loaded into each of the amplifiers. If this happens the SXRC display will flash FAILED and then show Manual SW Update Required . You will then need to perform a Manual Software Update (SW UPDATES Menu) as described on page 73 in this manual for each amplifier.

If you need assistance please visit your local KICKER dealer or contact KICKER Technical Services.

Installation

Step 3.) Press the ENT key to enter the Main	ESC	HOME	ENT
Menu of the amplifier.

Step 4.) Press the UP or DOWN key until the

Step 9.) The SXRC will display STARTING * while the amp(s) and remote are booting. When completed booting it will switch to * KICKER * . You are now in the

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

s t a rting *

MEM-1 MEM-2 MEM-3 MEM-4

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE GAIN EQ LPF HPF PHASE KOMP

display reads SYSTEM. Press the ENT key to enter the System Menu.

ESC HOME ENT

Default Menu.

* kiicckkeer *

MEM-1 MEM-2 MEM-3 MEM-4

Step 5.) Press the UP or DOWN key until the display reads Remote adr. Press the ENT key to enter the Remote Address Selection Menu.

ESC HOME ENT

Step 10.) Press the ENT key one time to enter

the SXRC Main Menu. The first Main Menu item will
be displayed which is AMP ADJ.	ESC	HOME	ENT

Step 6.) Press the UP or DOWN key to select the Remote Address you want to assign to this amplifier. Press the ESC key three times to save your setting and return to the Default Screen.

ESC HOME ENT

Step 11.) Press the UP or DOWN key until the display reads SXRC SETUP . Press the ENT key to enter the SXRC SETUP Menu.

Step 12.) Press the UP or DOWN key until the display reads AUTOSearch . Press the ENT

ESC HOME ENT

Step 7.) Repeat steps 3 through 6 for each amplifier.

key to activate the AUTOSEARCH function.

ESC HOME ENT

17 SXRC Remote Control

17