A few words on the Kompressor™. The effect is most noticeable in the bass area of your music (Bass/Midbass). You can use the Kompressor™ in any amplifier configuration

(Low Pass, High Pass, Band Pass or Full Range) but we feel the most dramatic results are obtained when the amp is in a Low Pass (subwoofer) or Band Pass (midbass) situation.

A few exceptions to this statement are:

The red-linesetting is good for use in any configuration as it helps control dynamic peaks and limit distortion at higher output levels. VERY effective at controlling speaker damaging distortion caused by over-driving or clipping the amplifier.

The contour setting is also another good all around use setting and when used in Full Range or High Pass configurations tends to enhance the vocal and top end of the music. Great for helping to cover up interior noise.

The ATTACK setting is really geared for bass and midbass duty but can be used in any setup.

Remember, these are just suggestions, play around with each Kompressor™ preset and the Threshold (KOMP ADJ) to find what works for you.

The possibilities are almost endless! Tweak away!

SXRC Specifications

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE

GAIN EQ LPF HPF PHASE KOMP

* kicker *

ESC

HOME ENT

MEM-1 MEM-2 MEM-3 MEM-4

M1 M2 M3 M4

Operating Voltage:

9-16 volts DC

Remote Turn-On Voltage:

9-16 volts DC

Internal Fusing in SXRC

 

Interface Box:

Mini Glass Fast Blow 3 amp

Maximum Amplifiers:

16 units

Maximum Groups:

10 groups

DRVC Range:

30 dB

Power, Ground, Remote

Removable plug will accept

Terminals:

up to 12 gauge wire.

Mounting Hardware:

Standard DIN 7-3/16 x 2-1/8

 

182mm x 53mm

Specifications

SXRC Remote Control

79

Page 79
Image 79
Fortinet 2 SXRC manual Operating Voltage, Remote Turn-On Voltage, Internal Fusing in Sxrc Interface Box, Maximum Amplifiers