Fortinet 2 SXRC manual Kicker

Installation

Using the R-Tool

The included R-Tools are used to remove the SXRC Control Head from the Trim Ring/Metal Cage assembly. The R-Tools simply slide into the notched area on both sides of the Plastic Cosmetic Trim Ring and will release the clips holding the SXRC Control Head.

Wiring

Now that you have mounted your SXRC Control Head it is time to do some wiring. The first step is to plug your SXRC Control Head into the SXRC Interface Box.

SXRC TO

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE

GAIN EQ LPF HPF PHASE KOMP

*	kicker *			ESC HOME	ENT
MEM-1	MEM-2	MEM-3 MEM-4
M1	M2	M3	M4

	FROM AMP		+	12V	REM	GND
	Interface Box
AMP1		AMP2
LOCK LEFT SYS RIGHT MUTE
GAIN EQ LPF HPF PHASE KOMP
*	kicker	*				ESC HOME ENT
MEM-1	MEM-2 MEM-3	MEM-4

Power On

LED

PS2 - SXRC

Connector

R-Tool R-Tool

M1 M2 M3 M4

Control Head

Next, run a fused (5 amp) constant 12 volt, ground and remote turn on to the SXRC Interface Box. Connect the wiring to the removable power plug by loosening the set screws, inserting the stripped wire and then tightening the set screw.

Strip Back Wire

1/4" (6 mm)

HyperFlex

HyperFlex

HyperFlex

Ground

Remote

5

+ 12 Volt

	Fuse
Loosen Set Screw	Tighten Set Screw

12 SXRC Remote Control