Fortinet 2 SXRC manual Go back and double check your Communications Network

NOTE:

If steps 15-20 worked correctly, you should now have two SX

Step 21.) If you are only controlling only two

Communication

Interface Box Network Jack (RJ45)

Series amplifiers updated and brought into the SXRC Communications Network, skip to step 21. If not, then read on.

If the display came back blinking 1 Units after doing the AUTOSEARCH then there is a problem with the Communications Network.

SX Series amplifiers with the SXRC (sure ...sure ...

we know you have them stacked up!) you can skip to the next section in the manual titled Operation.

SXRC TO
		V	RE	M		ND
FROM AMP	+	12			G

5-Meter Network Cable

Power, Ground

Remote Jack

	Ground
HyperFlex
			Remote
HyperFlex
		5		+12 Volt
HyperFlex

Fuse

AMP STRAPPING

IN OUT

IN OUT

• Go back and double check your Communications Network

cable between the first and second amplifier and make sure it is

inserted properly and ‘snapped’ into place.

• If you have purchased different cables, double check that they

are Straight-Through Ethernet Network cables.

If you have more than two SX Series amplifiers to control then continue with Step 23.

Step 22.) Plug the

1-Meter Network Cable

AMP STRAPPING

Installation

• If you have made your own cables double check them for

secure and proper termination.

Communications Network Cable from the REMOTE IN jack on the third ampli-

IN OUT

IN OUT

• Did you check the pins (#1 and #8) in the SX Series

amplifiers to make sure they are not bent or damaged?

fier into the REMOTE OUT jack of the second amplifier in the chain.

1-Meter Network Cable

AMP STRAPPING

You have to get the Communications Network working with the second amplifier and update its software before we can proceed

Even if you have more than three amps, at this point only the first, second

IN OUT

IN OUT

with the rest of the amplifiers so double check everything. Try a different cable if necessary. Repeat steps 15-20 after double checking your cables and jacks. Once the second amp is successfully updated and in the Communications Network you can move on to step 21.

and third ones should be connected as the diagram on the right shows.

Additional Network Cable

(Supplied By You)

To Next Amplifier

SXRC Remote Control 21