Fortinet 2 SXRC manual Run the supplied

Now we can run the Network Cables from the SXRC Interface Box to your SX Series amplifiers to create the SXRC Communications Network.

SXRC Network Cables

The SXRC is supplied with 3 Network Cables, one 5-meter and two 1-meter. This is enough to connect 3 SX Series amplifiers to

Run the supplied

Communication

Interface Box Network Jack (RJ45)

the SXRC Interface Box. You can connect up to 16 SX Series

5-meter Network Cable from the Interface Box to the REMOTE IN jack of your first SX Series amplifier.

SXRC TO
		V	RE	M		ND
FROM AMP	+	12			G

5-Meter Network Cable

Power, Ground

Remote Jack

	Ground
HyperFlex
			Remote
HyperFlex
		5		+12 Volt
HyperFlex

Fuse

amplifiers to the SXRC by supplying additional cables.

If you need additional cables or need to use custom lengths, you can purchase pre-made cables at any computer or electronics store. You want to purchase a Straight-Through, Ethernet Network Cable.

Installation

Run the first supplied 1-meter Network Cable from the first SX Series amplifier’s REMOTE OUT jack to the REMOTE IN jack of the second amplifier.

AMP STRAPPING
IN	OUT	IN	OUT

1-Meter Network Cable

AMP STRAPPING
IN	OUT	IN	OUT

If you want to make your own custom length cables you will need:

•Bulk Cat3, Cat5, Cat5e or Cat6 network cable. •Crimp on RJ45 plugs.

•Cable cutters. •Electrician's scissors. •RJ45 crimp tool.

Run the second supplied 1-meter Network Cable from the second SX Series amplifier’s REMOTE OUT jack to the REMOTE IN jack of the third amplifier.

1-Meter Network Cable

AMP STRAPPING
IN	OUT	IN	OUT

•A UTP/Network Cable stripping tool.

Step 1.) Cut a piece of net- work cable the required length from the bulk cable roll using your Cable Cutters.

You can continue adding amplifiers (16 total) by following this setup and supplying your own Network Cables.

Additional Network Cable

(Supplied By You)

To Next Amplifier

￿

14 SXRC Remote Control