Fortinet 2 SXRC manual Blue-White Green-White, Blue Green, Orange-White Brown-White

Network

Cable

Step 2.) Using the UTP/Network Cable stripping tool, remove

1 inch (25 mm) of the outer insulating jacket from each end of the cable exposing the 8 wires (4 twisted pairs).

Pair 1	Pair 2	1 inch
•Blue-White	•Green-White	(25 mm)
•Blue	•Green
Pair 3	Pair 4	Network
•Orange-White	•Brown-White
•Orange	•Brown	Cable

Step 3.) Untwist the 4 wire pairs on each end back to the outer insulating jacket and lay them in this order.

•Orange-White •Orange

•Green-White •Blue •Blue-White •Green

•Brown-White •Brown

NOTE: The wires must be cut at a 90 degree angle to insure proper fit in the RJ45 plug.

Network Network

Cable Cable

Yes ! No !

Step 5.) Slide an RJ45 plug (clip side down) onto the cable and seat it fully onto the cable. The 8 wires should butt up against the end of the plug tightly. Crimp the plug onto the wire securely using the RJ45 Crimp Tool. Repeat the process for the other end of the cable.

Network	Network
Cable	Cable

Yes ! No !

Step 6.) Lay the cable ends side by side (clip down) and verify the wire colors are in the correct order. The ends should be identical. If they are not, cut off the incorrect end and return to step 2 to put on a new RJ45 plug.

Installation

Step 4.) Hold the now grouped and sorted wires together tightly and using the Electrician's Scissors cut them all 1/2 inch (13 mm) in length at a 90 degree angle.

1/2 inch (13 mm)

Network

Cable

90°

	1			1-Orange-White
Network	2			2-Orange
	4
		3
Cable			5	3-Green-White
	6
	7			4-Blue
	8
	1			5-Blue-White
	2
Network		3		6-Green
		4
Cable			5	7-Brown-White
	6
	7			8-Brown
	8

SXRC Remote Control 15